Hifonics Sampson

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
I REPLACED THE OUTPUTS IN THIS AMP ALONG WITH THE DRIVER IC'S AND A 330 OHM RESISTOR ON THE DRIVERBOARD.

WHEN TRYING TO POWER THE AMP UP THE RELAYS CLICK ON FOR A SEC THEN CLICK OFF AND AMP GOES INTO PROTETION.

IF I REMOVE THE OUTPUT DRIVERBOARD AMP POWERS UP BUT THE GREEN LED DOESNT LIGHT WITH OR WITHOUT THE DRIVERBOARD.

ANY IDEAS ON WHERE TO CHECK?
 
Heres a pic of the driverboard
 

Attachments

  • hifonics 075.JPG
    hifonics 075.JPG
    812.6 KB · Views: 147
Back to this amp again.

I replaced all outputs and let the amp sit for awhile now when i try power it up it draws excessive current.

If i disable the output section amp powers up fine and idles around 5 amps.

I checked all outputs in the amp they all tested fine I also have the output driverboard removed.

Any thoughts on where to check or do i need to take all outputs back out of the amp and check for leakage?
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.