Corroded wire now fixed, amp wont turn on now.

[BlownAmp]

So I did something extremely stupid and lazy but before I here how stupid I am just know I am kicking myself now. My amp started to cut in and out. It wouldnt cut out often but it did once in a while (I could indicate it by the light on my dial. I ended up turning off the output from my stereo until I tore it apart, but didnt unplug, or anything, and amp still turned on with stereo. Now my light kept intermitantly coming on and off for a few weeks with the amount the light was on getting shorter and shorter until it didnt turn on at all(I know, its bad). I finally checked and my power wire was corroded and not giving the power needed. So I changed the wire, but now the Amp doesnt turn on at all. My question is would I have fried my amp by having the power intermitantly on and off to it or would it be a fixable thing? Fuses are fine and the circuitboard shows no signs of physical damage and all the activator, power wire, ground etc are all working fine with my multimeter. Thanks

[Perry Babin]

Did you place the black meter probe directly on the ground terminal of the amp when measuring the B+ and remote voltage? If, check the voltage again with the black probe directly on the amp's ground terminal.

[BlownAmp]

Thanks, I will try this, thought I did, but could be wrong. I'll let you know my results.