Hifonics gen X Thor

[mike49504]

Ok next amp.

This amp powers up fine but there is no output out of either channel.

Wondering what to check?? since the outputs all test fine

[Perry Babin]

Is it producing both positive and negative rail and regulated voltages?

Does the amp have a preamp board connected to the main board via a ribbon? If so, confirm that the preamp board is receiving regulated voltage and confirm that audio is getting from the preamp board to the main board.

If it's using the plastic RCA jacks, confirm that the shield ground connection is not broken.

[mike49504]

The preamp board is recieving power .

AT the outputs the middle leg shows low voltage outer two legs of the ouputs read 0

[Perry Babin]

What voltage do you have on the center legs of the outputs (positive and negative voltages)?

[mike49504]

ok heres what i have on the outputs

on the tip41 c 1.88
a968 1.48
c2238 1.18

then there 2sc or 2sa chip i cant make out the numbers since they are worn off but they read 1.18

all middle legs is where im getting my readings and ground to the chasis of amp

Getting no negative reading on the middle legs of theese parts

[Perry Babin]

Place the black probe on the secondary center tap or on one of the non-bridging speaker terminals and measure the voltage again.

[mike49504]

ok put the black meter probe on a non briding output.

tip41c= -0.18

a968= 0

c2238= -0.33

2sa or 2sc parts = -0.33

[Perry Babin]

What is the voltage on the center legs of the output transistors (TIP35C36C?)?

[mike49504]

i think what they are using for outputs are 2sc1302's there are no tip 35 or 36's in this amp

the center legs of the 2sc1302's read -0.23

[Perry Babin]

Are you sure you have ±15v on the op-amps?

Do you have ~0 ohms between the 2SA/2SC output transistor emitters for each channel?

If not, do you have rail voltage on the emitters?