Hey, I own a rockford 350s amp, and I burnt my output mosfet. I want to replaced them but I dont know how to remove them from the heat sink.The problem is that the amp uses what Rockford call Mesha witch is the back of the mosfet (big metal connection for heat transfer) connected to a PC board then to the heat sink.Can anyone tell me if it is glued or soldered to that board.
Much thanks, steven123654.
Much thanks, steven123654.
They're soldered on. Read the following post. It was for the larger FETs but the procedure is essentially the same for the smaller FETs.
http://www.diyaudio.com/forums/showthread.php?postid=1901581#post1901581
http://www.diyaudio.com/forums/showthread.php?postid=1901581#post1901581
Are you sure that your outputs are defective? According to what I am reading from your other post, you may have a shorted speaker or a grounded speaker wire.
No I hev tryed with diffrent subwoofer 4 ohm and 8 ohm in car car and in my workshop.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.