|5th June 2008, 06:01 PM||#41|
Join Date: Oct 2007
Pin 14 of IC703 connects to middle leg of Q801.
And yes, i am completly sure. Followed the trace with magnifyer.
Its a clear and visible trace!
But i cant see this on schematic :S
It should have E14.3 C14.1 B13.1Volts.
And it has!! Not strange that IC703 has ~13 volts on leg 14..
Is it a possebility that there are slightly different versions
of this amp? Because the schematic does not seem to match.
Or is it just me...
Maybe i should just put everything back in place and se how it works. Its frustrating when the schematic does not match the
|5th June 2008, 07:20 PM||#42|
Join Date: Nov 2003
It's entirely possible that the schematic and the amp you have are different. Many amplifiers have multiple versions.
|Thread Tools||Search this Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Parallel LM3886, input ground, power ground, safety resistor and oscillations.||markiemrboo||Chip Amps||5||9th August 2007 04:50 PM|
|DC filament ground and high voltage ground||mikeyho||Tubes / Valves||0||15th September 2005 06:52 PM|
|Chassis Ground = Circuit Ground --> Problems?||rhildenbrand||Pass Labs||5||23rd April 2004 02:08 AM|
|does connecting mains ground with circuit ground create a ground loop?||jarthel||Everything Else||0||25th June 2003 01:55 PM|
|Should I directly connect my signal ground to chassis ground?||Bricolo||Solid State||3||28th February 2003 06:31 PM|
|New To Site?||Need Help?|