Help Needed - diyAudio
Go Back   Home > Forums > General Interest > Car Audio
Home Forums Rules Articles diyAudio Store Gallery Wiki Blogs Register Donations FAQ Calendar Search Today's Posts Mark Forums Read

Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Thread Tools Search this Thread
Old 30th April 2008, 06:52 AM   #1
d3cibel is offline d3cibel  Indonesia
diyAudio Member
Join Date: Aug 2006
Send a message via MSN to d3cibel Send a message via Yahoo to d3cibel
Default Help Needed

To all the bros here, i want to ask from the very beginning, to build a SPL competition car.
I'm still confused about the steps, my car is a Honda Jazz/Fit, i calculate the maximum dimension of my enclosure is (H x W x D) 101 x 50 x 55 cms.I will make the enclosure from a 25 mm MDF.And my sub and port will be facing up.
I will use 1 slot port for my enclosure and will use 1, 12 inch Pioneer Subwoofer TSW 307 D2 dual 2 ohms, and 1 Pioneer Amplifier GM 7300M rated at Max Output power in 14,4 V ,800 Watts at 2 Ohm load, 360 watts x 1 at 2 Ohm continuous power output.
Now, my question is : I want to search for my car's tuning frequency and cabin gain, do anybody can tell me the proper way to do this ?
Car tuning along with box tuning or build a box ,attach the subwoofer ,put inside the car and made another box ( sealed box) with predictive response ,also put in the car and then sweep the frequencies inside my car ?
Measurement of the SPL will be following the EMMA rules, and my car is right hand steering.They will put the Mic 65 cm above the driver seat.Will my tuning will take effect at the position of the microphone ?My car total length from back windshield to the front end windshield is 114 inches.And i measure roughly from the cone direct to the mic is about 64 inches.
I'm doing some calculations with the Win ISD pro alpha, and totally confused because of inputting the T/S parameters, Pioneer provide me complete T/S parameter except the displacement of the driver, but as i inputting the T/S to the Win ISD alpha pro, i got a very different T/S value calculated by the Win ISd, for the Qts, Qms ,Qes and several other parameter. So anybody can tell me which parameter should i use?
Any help will be much appreciated.Thank you all
study your judge carefully, get to know your opponents, then conquer !
  Reply With Quote


Hide this!Advertise here!
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off

Similar Threads
Thread Thread Starter Forum Replies Last Post
Help needed ! Inter M R300 schematics needed ! alexclaire Solid State 30 9th September 2009 06:14 AM
LT1964-adj Help Needed or Part Needed lgreen Parts 2 29th June 2007 02:50 PM
PSU Help Needed ardo Power Supplies 4 26th June 2006 05:15 PM

New To Site? Need Help?

All times are GMT. The time now is 09:07 AM.

vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright 1999-2017 diyAudio

Content Relevant URLs by vBSEO 3.3.2