Ads Mx 860 - diyAudio
Go Back   Home > Forums > General Interest > Car Audio

Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Reply
 
Thread Tools Search this Thread
Old 2nd April 2008, 01:28 AM   #1
capea4 is offline capea4  United States
diyAudio Member
 
Join Date: Apr 2008
Default Ads Mx 860

Hi all,

First off I would like to say that I am not a repair tech, just someone into audio equipment.
This thread is about my ads amp. It is an 860, not the 850 I see talked about on here. I have had the amp for some 5 years and it has always been great. Right now I have it out, getting ready to build a new system in a different car. I would like to take this chance to give something back to it. I understand caps die over time and abuse, so I was thinking about changing them out. Are there other components I should also replace? I have a nice iron, and plenty of experience soldering, but minimal with internal components.
Does this sound like a good idea? The amp is in good working order, I just dont feel the need to replace it, and would like to see many more years from it. This amp has 12 gauge wire from the fuses to each power supply, I was looking to see is I could maybe fit some 10. The ground jumpers is an 8, maybe a 6 could fit. Do any of you have experience with this amp? Even if not any suggestions are much appreciated.
  Reply With Quote
Old 2nd April 2008, 02:02 AM   #2
diyAudio Member
 
Join Date: Dec 2005
Location: Northern California
I change caps just about everyday for folks and I will say that they are some of the weakest components inside your amp. Mostly I see leaking caps where the chemistry inside the cap is actually leaking on to the board threatening the board and conductors. But these amps are 10 to 15 years old.

Your caps may still have lots of life in them, so it comes back to you and how you feel about preventative maintenance in order to protect your investment. If your caps are tested and they past muster, then there is no need unless your just being careful.

I have found that the caps value will drop off with age and abuse, so yes it cam make a SQ difference in your amp. Remember that the main caps that go bad do so from filtering the raw DC for your amps power, and by filtering the switching power supply so its noise will stay out of your 12 volt system < these are almost always in need of replacement with enough age..

While your inside your amp, try to replace any Silicone heatsink compound if your amp has it at all. Silicone tends to dry out and creep with heat and age. It will creep so bad that the paste drys up to a crusty power that has very poor thermal transfer ability.

There isn't much more you can do to protect your investment, but just like changing fluids in your car, something a pennies worth of prevention saves a pound of cure. I get to replace some more caps again tomorrow in a 15 year old PG MS-275, and I just replaced some today in a 20 year old PPI A600.2......Hope this helps.
  Reply With Quote

Reply


Hide this!Advertise here!
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



New To Site? Need Help?

All times are GMT. The time now is 01:50 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio

Content Relevant URLs by vBSEO 3.3.2