diyAudio - tauro0221
Go Back   Home > Forums > Blogs

Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Old

Jig to help soldering SMD components

Posted 31st October 2013 at 10:12 PM by tauro0221

Hi,
I was searching for a jig that to help me soldering SMD components to the board but unsuccessfully was unable to find one. Specially when your are an older person with checking hands like me. So I decided if you do not find it built it. Checking my junk box found some parts that allowed me to came out with this SMD holding down jig. It worked so good for me that I decided to share it with the diyAudio members.

To fabricate it I used a 1 x 8 inches aluminum strip and bent it like a square with one leg side cut out. Drilled a hole at the end of one of the leg and installed a 2 inches screw thru the hole and used one spring and holding it with a nut to applied pressure from the tip of the screw to the other side leg of the square. I think that a picture it is better than words specially when you are not a technical writer like me.
Attached it is a picture showing the final SMD soldering holding jig.
Attached Thumbnails
Click image for larger version

Name:	smd jig 002.jpg
Views:	594
Size:	477.4 KB
ID:	1156  
diyAudio Member
Posted in Uncategorized
Views 487 Comments 1 tauro0221 is offline
Hide this!Advertise here!

New To Site? Need Help?

All times are GMT. The time now is 07:52 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio

Content Relevant URLs by vBSEO 3.3.2