EMT 950 Turntable - diyAudio
Go Back   Home > Forums > Blogs > Davo58

Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Rate this Entry

EMT 950 Turntable

Posted 31st August 2011 at 05:00 AM by Davo58

Has anybody had to try and play discs that run at slower speeds than 33 rpm.
We have some 24 rpm and 16 rpm discs that we need to digitise and was wondering if you hve been able to slow down your EMT950 to be able to do this.
Posted in Uncategorized
Views 1239 Comments 1 Email Blog Entry
Total Comments 1

Comments

  1. Old Comment
    kevinkr's Avatar
    This should probably have been posted in the analog source forum. It's very unlikely to get any action here.

    Look at the Siemens Micromaster line of AC motor drives, they can provide 3 phase power to the motor and can be precisely adjusted to a wide range of frequencies which should make it possible to run your table at odd speeds.

    MICROMASTER - English - Siemens

    As a moderator I would offer to move this, but I am not sure how..
    permalink
    Posted 1st September 2011 at 05:53 AM by kevinkr kevinkr is offline
 
Hide this!Advertise here!

New To Site? Need Help?

All times are GMT. The time now is 10:30 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio

Content Relevant URLs by vBSEO 3.3.2