D1080 MkII 08 actives - power supply mod details - diyAudio
Go Back   Home > Forums > Blogs > abraxalito

Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Rate this Entry

D1080 MkII 08 actives - power supply mod details

Posted 17th December 2010 at 03:34 AM by abraxalito
Updated 5th March 2012 at 02:54 AM by abraxalito

When considering how to hot rod a particular piece of electronics, my first attention always goes to power supplies and layout rather than the somewhat more popular approach of swapping out components for boutique variants. This is because so far I'm not sure that I notice the differences between audiophile grade caps (for example) and the bog standard ones. But I am sure of the differences brought about by improved grounding - to my ears these aren't subtle changes at all. So if I turn out to be dissatisfied with the sound of my layout mods, then I'll turn to tweaks on individual parts.

On examining the layouts of the two PCBs (XO layout already shown in a prior post) it turns out the amp PCB is the one with the relevant power supply components. In more detail, it has two independent supplies coming from separate windings on a standard EI-core transformer. The higher current one is unipolar, unregulated and feeding only the TDA8947s, the small-signal supply is bipolar, regulated and goes only to the XO board via a 3-core cable.

So first up - improving the regulated supply. It uses LM78/79L types which have poor HF rejection, so I normally install an RC filter on the input side to deal with this. Here I used 22R (actually two 47R paralleled) and 47uF as I had them to hand. Already there are 0.1uF on the input side, so these go in parallel with the added electrolytics. Snubbers are included across the diodes, which here are all discrete. Values I used are 470R and 470pF in series. These serve to soak up the RF emissions on diode turn-off.

Finally I hack the ground traces to provide clean feeds from a star ground to get ground references to be as quiet as possible. Once a decoupler is connected to a ground, I consider that a dirty ground, even if the power supply is regulated upstream. The regulators here have fairly high output impedance at the lowish output currents needed for a couple of quad opamps, so there's plenty of potential for cross-coupling via supplies.

The results of all the snubbers, filters and star grounding can be seen in the photo of the underside of the board.

The unregulated supply is reserved solely for the chipamps, it turns out that the negative side of this is connected to 0V of the bipolar supply. The chip amps have separate power supply grounds for the inputs and outputs, but here they've been joined. So its necessary to separate them which requires a bit of hacking with the craft knife and strapping with the ubiquitous yellow wires. Input grounds are lead off to the star point with their own dedicated connection. An integrated bridge rectifier is used, each internal diode has its own snubber.

The interconnection between the two supplies has been re-routed too, to minimise common impedances. The PCB shows the designer had some inkling of star earthing, but he didn't quite take it far enough for my liking...
Attached Thumbnails
Click image for larger version

Name:	P1010001.JPG
Views:	1328
Size:	671.9 KB
ID:	303  
Views 1301 Comments 0 Email Blog Entry
Total Comments 0

Comments

 
Hide this!Advertise here!

New To Site? Need Help?

All times are GMT. The time now is 07:50 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio

Content Relevant URLs by vBSEO 3.3.2