diyAudio - Entries for April 2013
Go Back   Home > Forums > Blogs > abraxalito
Home Forums Rules Articles diyAudio Store Gallery Wiki Blogs Register Donations FAQ Calendar Search Today's Posts Mark Forums Read

Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Old

Force/sense shunt

Posted 24th April 2013 at 08:35 AM by abraxalito
Updated 24th May 2013 at 03:59 AM by abraxalito (Added pics of prototype fs-shunt. Added noise update.)

I'm a recent convert of the lowest possible impedance of power supply based on my experience of adding caps to my chipamp. So I figure the signal stages can't be harmed by reducing their supply impedance either, particularly at LF.

I note there are a few aftermarket regulators around - I had a look at Paul Hynes and Belleson in the past few days. They're a bit pricey for my tastes, given the cost of the components they're using can't be over single digit $ so I've had a look at "doing it at home, only cheaper".

First off, a simple TL431 is about the best bang for the buck achievable, as the part here is 0.2rmb. But the dynamic impedance is typically 0.2ohms and I was hoping and aiming to go a bit lower than this - perhaps an order of magnitude lower, to around 10mohms. Lower than this and the resistance of the PCB tracks come into play and its also very hard to maintain such a low impedance beyond the audio band as cap ESRs (for the best ones) are of...
Attached Thumbnails
Click image for larger version

Name:	fs-shunt-LTSpice.png
Views:	1479
Size:	25.5 KB
ID:	966   Click image for larger version

Name:	fs-shunt-plot.png
Views:	366
Size:	5.6 KB
ID:	967   Click image for larger version

Name:	fs-shunt-alpha.png
Views:	355
Size:	210.7 KB
ID:	970   Click image for larger version

Name:	fs-shunt-alpha-rev.png
Views:	426
Size:	188.8 KB
ID:	971  
abraxalito's Avatar
diyAudio Member
Views 1308 Comments 1 abraxalito is online now
Old

Active elliptic - practical implementation

Posted 20th April 2013 at 09:33 AM by abraxalito

Here's the first channel under construction on 2mm pitch double-sided proto board. The opamps in this instance are AD8014 in SOT23-5 packages, hence the choice of the 2mm pitch board. Power supplies will go on another board to be attached to the reverse side.
Attached Thumbnails
Click image for larger version

Name:	active-ellptic.png
Views:	278
Size:	891.7 KB
ID:	965  
abraxalito's Avatar
diyAudio Member
Posted in Uncategorized
Views 523 Comments 0 abraxalito is online now
Hide this!Advertise here!

New To Site? Need Help?

All times are GMT. The time now is 10:58 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2016 DragonByte Technologies Ltd.
Copyright 1999-2016 diyAudio

Content Relevant URLs by vBSEO 3.3.2
Wiki