diyAudio - Entries for April 3, 2014
Go Back   Home > Forums > Blogs

Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Old

One Farad capacitor array

Posted 3rd April 2014 at 04:08 AM by abraxalito
Updated 4th May 2014 at 05:53 AM by abraxalito

This array of 127 10,000uF caps measures -j2.9mohms at 50Hz which I reckon makes it comfortably over 1F in capacitance. ESR is 1mohm @ 50Hz.

The individual caps were measuring on average 8,500uF. Although they're marked 10V (the brand is ChengX a slightly shady Chinese one) they're not good for anywhere near this voltage. I reckon they're in reality 6.3V and they seem to have decently low leakage at this working voltage. I shall be using them at 5V or below.

Update1 - seems I wasn't using enough copper in the wiring. I've now built a second one with 2.5mm2 wiring around the loops and 1.5mm diameter cross links and ESR is down to 0.5mohm @ 50Hz now, decreasing at higher freqs. I have enough caps left for a third one...

Update2 - now the first array has a basement level giving 2.1F total with ESR below 0.4mohms @ 50Hz. There are six paralleled TDA1387s atop the combined hexagons giving unprecedented LF dynamics. Amp long, long overdue for an upgrade.......
Attached Thumbnails
Click image for larger version

Name:	P1010094.JPG
Views:	458
Size:	693.3 KB
ID:	1264   Click image for larger version

Name:	P1010095.JPG
Views:	559
Size:	708.6 KB
ID:	1269  
abraxalito's Avatar
diyAudio Member
Views 878 Comments 10 abraxalito is offline
Old

The case of the crazy Sapphire amp.

Posted 3rd April 2014 at 02:24 AM by rjm
Updated 3rd April 2014 at 12:07 PM by rjm

Case report:

A set of Sapphire boards gave the proper V+, V- voltages out of the Z-reg, providing about 10.5 and -10.5 to op amp power pins. The output offsets were unusually high however, apparently at about 2 V in one board, and somewhat less in the other. Typically the offsets are in the order of +/-15 mV.

Changing out transistors and op amps did not help, and to all inspection the passive components were installed correctly and working properly. The offset voltages were extremely temperature sensitive. Measurements for the various circuit voltages were just screwy enough to be inconclusive.

I could ask for no more tests, so requested the boards be sent back to me. I found the circuit basically worked as expected, but the offsets were indeed high on both boards, though I measured 0.6 V max rather than 2 V.

***** stop here and make a guess *****

Blowing on the board through a soda straw, the offset shot up when I blew on...
Attached Thumbnails
Click image for larger version

Name:	DSC_1611s.jpg
Views:	177
Size:	405.5 KB
ID:	1263  
rjm's Avatar
rjm
diyAudio Member
Views 434 Comments 0 rjm is offline
Hide this!Advertise here!

New To Site? Need Help?

All times are GMT. The time now is 07:42 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio

Content Relevant URLs by vBSEO 3.3.2