Here are some pictures of the Power Supply that CRT and myself designed for use with the F5T and F6Convertible design. It is meant to be both compact, have adequate capacitance, and be able to use the recommended MUR3020W or similiar diodes. They are 2.5mm thick boards with 3OZ copper thickness.

Boards measure 170MM x 95MM. The diode boards are 35MM x 95MM




The diode boards break off, and include room for Snubber cap and resistors. Here we see two different types of Wima .01uf caps being used. Both have 5mm diameter pins.
NOTE: The pictures here do not show the resistors installed. In this case, the caps do not work. RC snubbers have the resistor in line, so if you wish only bypass caps, then you must jumper the R's.
I get questioned on resistor value - I use 100R, but have...