diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Audio Sector (http://www.diyaudio.com/forums/audio-sector/)
-   -   It works (http://www.diyaudio.com/forums/audio-sector/155962-works.html)

robocow 1st December 2009 09:30 AM

It works
 
Hi Peter,

Just to say thank you very much, received kit and completed one in an evening. I very happy, as I only have a little experience, and a little knowledge. Completed kit sounds quite good, although only had a short listen at this point!
I do have to ask about that choice of mute resistor, why the SM device? When everything else is so easy, that kinda stands out as being quite tricky!

While I'm here, in your opinion, is it OK to go on and use the two boards as 4 x mono for active crossover purposes?

Peter Daniel 1st December 2009 05:13 PM

1 Attachment(s)
The main reason for SMD was location. It's place right under the pins of the chip and there was no way I could use through hole part. With a help of tweezers, it's quite easy to install too.

Sure, it will work very well as 4 separate channels.


All times are GMT. The time now is 03:29 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2