View Full Version : Multi-Way
- 2-way speaker using T330d esotar & MW170
- Low power Woofer
- 2 octave above Fs 1360
- First Project HATT-SE
- Does furniture obstruct modal resonances?
- confusion: aperiodic enclosure stuffing
- Fostex FT207D tweeters
- New product from West Systems
- Hi-Vi W6, Silver flute W17RC38 or Dayton RS150s
- Small Speaker Box's - Building - Components - Materials - Testing
- Active PA X-over for HiFi use
- Question about speaker wire length
- DIY virtual surround / 5.1 speakers front placement
- Peerless 830843 sub as a woofer in 3 way
- Compression drivers in horns or waveguides
- Should I seal the back of my speakers?
- SPCA Special Plans Needed
- fostex ff85k as a mid-hi in 2 way speaker
- room size and speakers
- power distribution and sensitivity in a 3 way
- building a set of diy-dynaudio
- Seas 27TBFC/G vs Usher 9950 and woofer for them
- 3 way MTMB
- Radio Shack Minimus 7 repair
- Jay's ER18RNC_27TDFC finished
- JBL 2226H & 2426H cd/2370 horn combo in OB project..?
- 3.5 way towers
- Horn 9800 drawing Need help
- Scoperta - Mini TL
- Tannoy upgrade, from 609s to...?
- Celestion Ditton 33 woofer not working
- Series vs Parallel for dual Accuton Woofers
- suggestions for designing OB/dipole using AN's
- Techniques and Materials for Spheres and Ovoids
- Onken for 10" or 12" drivers.
- Tannoy 609 compared with Tannoy 615
- Coral tweeter sidethread
- Yamaha NS-1000 Tweeters Wanted Urgently
- B&C 8PE21 on Tractrix horn
- a design
- Beyond the Duelund 3-way crossover
- variable treble attenuation
- Making different drivers cover same range
- x-over design
- anyone recognize 902-5861?
- DIY mini speaker project
- No Bottom E?
- I Don't Understand.
- EPI 110C speakerset
- Acoustic Modeling Software
- help filter
- High pass shelf network
- Car speakers in the home??!
- AR3a "improved" - It works!
- Speaker repairs
- HiVi D6.8 & HiVi Q1R
- 3 years worth of DIY Madness (somebody Help me)
- Yamaha tweeters on Ebay
- Diy "Hi-Fi" Bass Rig
- NSB, sealed?
- Build Replica IMF Transmission Line Speakers???
- What tweeter above a Feastrex as mid?
- From Power Compression towards Thermal Distortion / developing on a point of view
- KEF 105.2 crossover networks
- Need help with design
- Proac Studio200 - Upgrade mods help needed
- Need A Design - Small (11-12L volume) & High(ish) Output
- What impedance?
- Need good drivers for 'copper' speaker cabinet
- OB any science to it?
- choosing specs for driver that will be used for OB
- Crossover advice
- Where to buy Lyeco/Dynavox drivers??
- What type of wood is really used in Commercial Speaker?
- Infinity IRS Beta Mods Query
- Cabinet manufacturers in India
- Room Gain Complementary (RGC) tuning
- 6 ohm to 8 ohm
- Mass Confusion
- How to convert sensitivity values
- Custom Home Theater Project in New Home, Opinions appreciated.
- Building a 2.1 system out of a 48"x96" sheet of 3/4" MDF
- Remagnetizing vintage loudspeakers
- Redesign of JBL L-100 pair
- Determining Xover Point with Waveguide
- Software for Sound System Design
- b&w nautilus inspired speakers
- jamo d365
- CSD/Waterfall low frequency noise prolem
- Accuton vs OWII / Audio Technology
- Seas L18 / Seas 27TBFCG
- low-pass crossover suggestions
- Equation relating t/s parameters to sensitivity vs frequency
- How do you advise I cross these speakers to a sub?
- german DIY forum searching
- FAO: Scottmoose
- Identity of two vintage drivers?
- HDMI question
- Vifa P17wj and D27 tg series x-over
- Blown tweeter Revel Saoln
- options for Silver Flute project?
- I need 3D CAD Cabinet ONLY Modeling Software
- isodynamic? whats that.
- New Member Lost my Bass in Speakers...HELP
- Replacement driver needed for PC spkrs Altec Lansing ACS48, 3"
- Which drivers for my next open baffles?
- M&k
- From the ashes of Burning Amp: the Peerless 850397-based 'LoudFreeker'
- Design suggestions using 6.5” Peerless NPT-11-078-1
- van den hul cable clone wanted
- Scanspeak Drivers vs. ????? , should i go with something else.
- jamo d365 speakers
- high efficiency 3way.
- Designing my Dream Theater audio system
- Speaker Driver Brand Question
- at what frequency are inductors measured
- Open baffle, the theory behind it and benefits.
- Vertical WTMW driver alignment - pros and cons
- dynaudio 330 ,scan8545
- Dayton PK165-8 6" Professional Kevlar/Paper Cone Midrange
- Hales transcendence 8
- Speaker building supplies in Melbourne
- Saba Alnico XXL woofer 12"
- Praxis vs Sample Champion
- 18sound 21LW1400
- need suggestion with filter
- Casting papier-mache as speaker enclosures
- Burning Amp - free NHT woofers..?
- Altronics 8" on special
- Attn. Dr. Geddes: What about acoustic lenses?
- xmax on unibox
- 10" MTM with NeoPro5i Ribbon - Build Thread
- Looking for 3-way with Vifa P11MH09 (8 ohm)
- Onken cabinet
- Questions on loudspeaker coil design
- resistor for crossover
- Ambiophonic optimal source distribution experiment (part 1: Introduction)
- Withworth bolt for AR3a?
- PE 12" co-ax
- Active cinema speakers
- Celestion "1"
- comment on hornresponse sim
- Opinions: Dynavox TD2801XL
- New Open Baffles (Gift for friends )
- Adding a bucking magnet, what effects does it have
- 2 versions of vifa XT18
- Flux modulation
- Mcm 55-3862 ?
- series connection question
- Aurum Cantus G2Si or Fountek NeoCD3.0
- My most recent tower design
- AURA 1" searching
- Fraud !!!
- Ribbon Tweeters with Scanspeak Revelator 15W or Seas Excel W15?
- add a subwoofer to my Proac super tablette
- Dipole woofer nonlinear distortion
- Can I do anything with these cabinets?
- Driver Data for Old Focal 7" Woofers?
- Unibox Run in Open Office?
- Bi Wiring and AWG
- Bass Effeciency, Driver, Tuning, etc.
- KRK RP10s Crossover surgery
- High efficiency 15"
- Macondo speakers from Romy the cat
- Right cabinet for these vintage Coral drivers
- dealing with modal resonances in midrange transmission lines
- Peerless 850136 On Closeout at PE
- Vifa D25AG vs XT25TG30
- How to construct a elliptical waveguide for a tweeter?
- Thesis idea: Speaker distortion detection
- Peavey 22XT anyone got T/s specs?
- baffle step using a dbx260
- Baffles cut
- Loudspeaker design using Open Office Calc (or Excel)
- Speaker ID? Custom By CTS...?
- Naming notepad files to *.frd and *.zma
- Carbon nanotube loudspeakers
- Speaker Configuration
- Why is my woofer rattling?
- what 2' inverted soft dome, cheap
- Active JX92s monitors.
- Midrange Crossover: Choosing the least of all evils?
- Do drivers with cloth surround sound boxy?
- Interesting 'Labyrinth' paper
- Active vs. passive Xovers
- Rewind on existing voice coil
- Do I really require this box volume?
- Anyone have measured HI-VI D5.8?
- Software/Free tools
- MCM Driver Sealed Array
- Peerless SLS drivers, particularly 8" 830667
- Mordaunt Short 30i Classic
- Quick fix for an absent minded mistake
- my last design: 3-way/3-liters
- Help-Community CSX35 s2 Replacement parts
- Measuring distortion
- Cheap ways to get 98-100DB over 2.5Khz
- KEF Repair Help
- Dampening material query
- Loudspeaker that Emote. Is it...?
- Alternative Painting Methods.
- Introducing: the PET (SS 8545K + BG Neo3 PDR)
- Baffle profile – baffle edge problems?
- TDL RTL2 help
- Check out this creative idea
- Fiberglass stuffing and vented magnets
- Polarity of B&C DE250?
- Hybrid Dipole
- Ribbon tweeter/mid suggestions
- speakers for a wierd cabinet
- seas T14RCY/P-H and TPX cone
- Efficiency method to find VAS
- straight bass horn
- is L-PAD attenuator recommended for a 6 1/4 midbass?
- Skaaning 15H52 C-Queenze info
- Estimating leakage, absorption and port losses
- Driver suspensions
- Invitation to audition John K's OB NaO Speakers in Sydney 9/11/2008
- Center channel to match Exodus 2641
- Resonances transformed to thermal energy??
- Audiomaster Speakers
- Aurum Cantus AC-200MKII 8" what the heck!!
- Cabbinet for monacor sph-170, hornloaded? TL? BR?
- insert t nuts
- extracting enclosure Qb parameter
- Any experience with Monacor SPH300-KE ?
- martin j king's sheets
- Vandersteen 2C replace fabric grill cloth
- What do you gents think about building a box with this material?
- What is the best way to reduce speaker cabinet volume
- Early Bose speaker value?
- Is AUDAX come back ?
- ScanSpeak Illuminator project
- Bose 901 + Tube amps
- “Loading” of tweeters in large drivers Coaxes
- Can anyone give me information on these Sony speakers?
- Can anybody identify this?
- Building a Center Channel
- Question for Dr. Geddes about his WG foam plug
- Alternative Speaker Workshop forum
- any DIY dipole surround plans?
- Why Scanspeak rising frequency response in woofers??
- Telefunken TLX 2 speakers for 1€ ??
- 2-Way DIY Project INDIA
- Relative merits of this vintage tweeter?
- Help with 3-way crossover frequencies
- Oris Swing discussion
- Sony SS-M3 drivers
- Speaker repair..
- Left loudspeaker keeps blowing