View Full Version : Multi-Way
- Replacement driver needed for PC spkrs Altec Lansing ACS48, 3"
- Which drivers for my next open baffles?
- M&k
- From the ashes of Burning Amp: the Peerless 850397-based 'LoudFreeker'
- Design suggestions using 6.5” Peerless NPT-11-078-1
- van den hul cable clone wanted
- Scanspeak Drivers vs. ????? , should i go with something else.
- jamo d365 speakers
- high efficiency 3way.
- Designing my Dream Theater audio system
- Speaker Driver Brand Question
- at what frequency are inductors measured
- Open baffle, the theory behind it and benefits.
- Vertical WTMW driver alignment - pros and cons
- dynaudio 330 ,scan8545
- Dayton PK165-8 6" Professional Kevlar/Paper Cone Midrange
- Hales transcendence 8
- Speaker building supplies in Melbourne
- Saba Alnico XXL woofer 12"
- Praxis vs Sample Champion
- 18sound 21LW1400
- need suggestion with filter
- Casting papier-mache as speaker enclosures
- Burning Amp - free NHT woofers..?
- Altronics 8" on special
- Attn. Dr. Geddes: What about acoustic lenses?
- xmax on unibox
- 10" MTM with NeoPro5i Ribbon - Build Thread
- Looking for 3-way with Vifa P11MH09 (8 ohm)
- Onken cabinet
- Questions on loudspeaker coil design
- resistor for crossover
- Ambiophonic optimal source distribution experiment (part 1: Introduction)
- Withworth bolt for AR3a?
- PE 12" co-ax
- Active cinema speakers
- Celestion "1"
- comment on hornresponse sim
- Opinions: Dynavox TD2801XL
- New Open Baffles (Gift for friends )
- Adding a bucking magnet, what effects does it have
- 2 versions of vifa XT18
- Flux modulation
- Mcm 55-3862 ?
- series connection question
- Aurum Cantus G2Si or Fountek NeoCD3.0
- My most recent tower design
- AURA 1" searching
- Fraud !!!
- Ribbon Tweeters with Scanspeak Revelator 15W or Seas Excel W15?
- add a subwoofer to my Proac super tablette
- Dipole woofer nonlinear distortion
- Can I do anything with these cabinets?
- Driver Data for Old Focal 7" Woofers?
- Unibox Run in Open Office?
- Bi Wiring and AWG
- Bass Effeciency, Driver, Tuning, etc.
- KRK RP10s Crossover surgery
- High efficiency 15"
- Macondo speakers from Romy the cat
- Right cabinet for these vintage Coral drivers
- dealing with modal resonances in midrange transmission lines
- Peerless 850136 On Closeout at PE
- Vifa D25AG vs XT25TG30
- How to construct a elliptical waveguide for a tweeter?
- Thesis idea: Speaker distortion detection
- Peavey 22XT anyone got T/s specs?
- baffle step using a dbx260
- Baffles cut
- Loudspeaker design using Open Office Calc (or Excel)
- Speaker ID? Custom By CTS...?
- Naming notepad files to *.frd and *.zma
- Carbon nanotube loudspeakers
- Speaker Configuration
- Why is my woofer rattling?
- what 2' inverted soft dome, cheap
- Active JX92s monitors.
- Midrange Crossover: Choosing the least of all evils?
- Do drivers with cloth surround sound boxy?
- Interesting 'Labyrinth' paper
- Active vs. passive Xovers
- Rewind on existing voice coil
- Do I really require this box volume?
- Anyone have measured HI-VI D5.8?
- Software/Free tools
- MCM Driver Sealed Array
- Peerless SLS drivers, particularly 8" 830667
- Mordaunt Short 30i Classic
- Quick fix for an absent minded mistake
- my last design: 3-way/3-liters
- Help-Community CSX35 s2 Replacement parts
- Measuring distortion
- Cheap ways to get 98-100DB over 2.5Khz
- KEF Repair Help
- Dampening material query
- Loudspeaker that Emote. Is it...?
- Alternative Painting Methods.
- Introducing: the PET (SS 8545K + BG Neo3 PDR)
- Baffle profile – baffle edge problems?
- TDL RTL2 help
- Check out this creative idea
- Fiberglass stuffing and vented magnets
- Polarity of B&C DE250?
- Hybrid Dipole
- Ribbon tweeter/mid suggestions
- speakers for a wierd cabinet
- seas T14RCY/P-H and TPX cone
- Efficiency method to find VAS
- straight bass horn
- is L-PAD attenuator recommended for a 6 1/4 midbass?
- Skaaning 15H52 C-Queenze info
- Estimating leakage, absorption and port losses
- Driver suspensions
- Invitation to audition John K's OB NaO Speakers in Sydney 9/11/2008
- Center channel to match Exodus 2641
- Resonances transformed to thermal energy??
- Audiomaster Speakers
- Aurum Cantus AC-200MKII 8" what the heck!!
- Cabbinet for monacor sph-170, hornloaded? TL? BR?
- insert t nuts
- extracting enclosure Qb parameter
- Any experience with Monacor SPH300-KE ?
- martin j king's sheets
- Vandersteen 2C replace fabric grill cloth
- What do you gents think about building a box with this material?
- What is the best way to reduce speaker cabinet volume
- Early Bose speaker value?
- Is AUDAX come back ?
- ScanSpeak Illuminator project
- Bose 901 + Tube amps
- “Loading” of tweeters in large drivers Coaxes
- Can anyone give me information on these Sony speakers?
- Can anybody identify this?
- Building a Center Channel
- Question for Dr. Geddes about his WG foam plug
- Alternative Speaker Workshop forum
- any DIY dipole surround plans?
- Why Scanspeak rising frequency response in woofers??
- Telefunken TLX 2 speakers for 1€ ??
- 2-Way DIY Project INDIA
- Relative merits of this vintage tweeter?
- Help with 3-way crossover frequencies
- Oris Swing discussion
- Sony SS-M3 drivers
- Speaker repair..
- Left loudspeaker keeps blowing
- beware of Audigy sound cards...
- TransLam Speakers
- Need Help with choosing Nagaoka-Style Horn
- 4way OB project
- push-pull with different T/S parameters
- adding mass to cone
- Determining a nominal impedance of a finished speaker
- center channel??
- Bracing Mods for P.E. Cab
- carbonfiber box
- tall, skinny ZD5 ?
- using 'steel wool' as box stuffing
- Any recommendation on using Vifa 1" ring radiator (XT25TG30-04)
- Any bad report on Vifa 1" (DX25TG05-04) tweeter
- 10" two way
- problem painting speakers
- Will active crossovers make cheap drivers sound well?
- Need to purchase ScanSpeak 6600 back cup
- DIY Surround speaker : please help
- Scan Speak voice coil problem?
- Peerless 810921 HDS tweeter mods? Updates?
- converting stereo into mono - help
- Linaeum Speakers on eBay-any good?
- Which wood for cabinet (?) and double check on driver selection.
- Low Rms woofers: your experience?
- Efficiency question
- Do we really belive that the goal is to reproduce live music?
- Winding ferrite corred inductors
- Why do they place tweeters far from the mid-bass?
- another biggest, most,
- Dr. Gedlee interview - bass extension
- DXC2496 and LeCleach Setup?
- LOUD speakers to integrate into Leather jacket. Which drivers are suitable?
- Suggestions / help wanted; low section in three-way ?
- Funny sounding speakers
- Anybody try the new MCM 55-3595?
- Which 8" driver
- Jamo Concert 8 Xover Coil Values
- Feedback: Fr125S & 2xExtremis6.8
- Zu Audio Definition, how do they do it?
- JBL 4312 cabinets
- Best "value" cap to build with???
- what mid is used in kef coda 7? isit B110?
- Devin's Aethers - measurement files attached
- porting a midbass
- First time 3-way speaker setup/crossover help.
- Orions sound great because dipole?
- Box volume newbie
- Open baffle line array nears completion
- Is it already hi-fi when...
- Shaker sub.??
- Crossover Help
- What to consider for car audio?
- ideal driver qts for aperiodic IB tuning
- Help needed with Vifa A10CC-07
- rs 150 mtm with series x-over
- any completely built speaker pics using VifaPL26w driver?
- Center channel with one mid
- Question about SPL
- Question regarding speaker selection and sensitivity
- beautiful and good sound speaker
- Will it work? My second-order two-way system design
- Tweeter for SEAS W15CY001 and L26RFX/P
- Horn Speaker Efficiency
- EV Eliminator Rebuild
- Closed end TL designs
- OB on a shoestring?
- Any know much abou the East German Schulz TH315 drivers?
- Aus: Altronics AL cone drivers
- dynamat for lining inside cabs
- Recone for a Peerless 830491 XLS8?
- Man Cave
- Simple DIYable Waveguide testing (dome tweeters)
- Tang Band w5-1611sa question..
- Diy Build - Morel Units / Active X-Over - Resin Cabs..
- Third order crossover query
- Do your speaker(s) dissapear?
- Vifa p17 D25 by John K
- Wavecor Listening Impressions
- Vifa P17WJ + D27TG-35-06 TL (non MTM)?
- Driver matching hardware and software.
- Tad Wood Horn Diy
- refinishing Tad et-703
- Vertical MT, horizontal woofer
- Distortion characteristics for Peerless paper & poly drivers
- Vifa DQ25SC16-04 design
- dynaudio 24w75 d52 d21
- Free modified AR3a "improved" crossover
- new woofer from morel
- Rmaf 2008
- Opinion on the speakers Beyma.
- improving diy loudspeaker
- Linn Katan/Ninka tweeters
- My Little Laguna
- One for the Aussies
- My latest find
- Thuneau PC XO
- Danish Physics Point Zero 1
- help with older speaker
- Home theater speaker - Advice needed
- Some intresting questions
- How to connect speakers in both stereo/mono?
- group order custom OS waveguides
- westra box help!