diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Analogue Source (http://www.diyaudio.com/forums/analogue-source/)
-   -   Need help on LINN armboard (http://www.diyaudio.com/forums/analogue-source/86393-need-help-linn-armboard.html)

NickBRN 13th September 2006 12:08 AM

Need help on LINN armboard
 
I need help on a new LINN arm which I made it...
By plexiglass!
Only one thing left, to open a REGA cut for my RB250
As I know the distance from the spindle to the centre of hole must be 223mm
The arm board 50mm x 300mm.
I wonder where excactly should be the centre of hole , perhaps right in the middle of 50mm side - I mean onto 25mm ?
Any help please!
Thanks

moray james 13th September 2006 01:45 AM

Years since I did this...
 
long time since I set up a tone arm. Mounting the arm directly in the centre of the arm board would be the position where you will get the most amount of structural motion as the distance to all the board edges will be the same. Offsetting the arm on your board will also offset the structural resonances of the arm/board combination. The same thing applies to a speaker on a baffle. Worth thinking about. Regards Moray James.

NickBRN 13th September 2006 08:36 PM

Thanks a lot Moray.

Well, I did a mistake about the dimentions of the armboard...
The correct dimentions are 100mm x 280mm, so the middle for the centre of the mounting hole must be on 50mm and not on 25mm as I described before...

But a friend of mine told me that the long side must be 280mm and not 300mm.
Is that correct ?
And what is the distance from the centre of the mounting hole to the back edge of the armboard ?

HELP PLEASE...!!!:scratch1:

vinylkid58 13th September 2006 08:58 PM

2 Attachment(s)
Here is the stock Linn arm location. I used the information that is available on the Vinyl Engine BTW. I will post twice.

Jeff

vinylkid58 13th September 2006 09:04 PM

2 Attachment(s)
The basic dimensions given are taken from my stock Linn armboard.
The Rega mounting location was derived from adding 12mm (223-211)
to the Linn hole center @65 degrees. I don't know what the Rega hole size is, I'm sure you can find this or measure the Rega base.

Jeff

NickBRN 13th September 2006 09:46 PM

Jeff,

I take my hat off...!!!

Thank you so much. :worship:


Nick

vinylkid58 13th September 2006 10:40 PM

My pleasure Nick. I may attempt this myself one day. Post a pic when you're done.

Best of luck.

Jeff

NickBRN 20th September 2006 02:00 PM

2 Attachment(s)
Here it is...

NickBRN 20th September 2006 02:00 PM

2 Attachment(s)
Another one....

NickBRN 20th September 2006 02:00 PM

2 Attachment(s)
Another one...


All times are GMT. The time now is 09:38 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2