What's a good test signal to match two decks' azimuth with?

[damianm]

Hi everyone

I've been using a cassette deck again for the past few months and would like to play my tapes in a couple portables I've got.

I was wondering what a good test signal is, something that will make it real easy to set azimuth by ear using just a tape with that signal and a screwdriver, as I've got no other equipment.

I find that I'm not particularly sensitive to small variations in steady tones, otherwise I'd just use a 10 kHz tone from a test tape. I've also tried using music with lots of HF content but I can never be sure if I've nailed it.


Thanks!

 

[Netlist]

10Khz is fine. If you have a scope you can adjust a little bit better but I recall setting azimuth on average decks by ear with good result.

/Hugo

 

[Ghianni]

Make a record of white noise (-20dB) then playback this noise on portables and adjust their azimuth by ear for the "sharpest" noise.
Ghianni.

 

[sreten]

Hi,

as suggested interstation noise from your fm tuner is probably best.

/sreten.

 

[Ghianni]

Yes that's it. FM interstation noise is like white noise.

Ghianni