VPI Diy table? anyone?

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
J

Jan I

Member
Joined 2004
Hello
I am working with one at this time.
I`ve bought the bearing and platter used .
This comes from a VPI 19 mkII
I am waiting for motor/power supply kit from Origin (standard set)
Her is what is done so far:
An externally hosted image should be here but it was not working when we last tested it.

You can see som more pictures here:
http://www.hifisentralen.no/cgi/yabb/YaBB.cgi/YaBB.cgi?board=diy2;action=display;num=1097996641
and here:
http://www.haudios.net/galleri09.htm
Sorry for my bad english

regards Jan I
 
J

Jan I

Member
Joined 2004
Ok Nate
I`ve just got my Origin standard motor/power kit:
An externally hosted image should be here but it was not working when we last tested it.


An externally hosted image should be here but it was not working when we last tested it.


Here is a picture of motor mounted in the DIY chassis:
An externally hosted image should be here but it was not working when we last tested it.


An externally hosted image should be here but it was not working when we last tested it.


An externally hosted image should be here but it was not working when we last tested it.


An externally hosted image should be here but it was not working when we last tested it.


Jan I
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom