Thorens TD-125 LB armboard dim's

[AuroraB]

I am about to refurbish a TD-125, and will also be making a new plinth. I was thinking of maybe making the plinth to also fit the LB armboard, but have not been able ti find the dim's for this.Also - does anyone know if there are some additional fixings except the usual three screews?

 

[kevinkr]

Best I can remember just the screws.. Check on Vinyl Engine - The Home of the Turntable , you need to be a member to access the library but I suspect there is plenty of useful information and probably a template there for making the plinth.

I didn't understand the arm board question, perhaps I'm dense.

 

[rayfutrell]

I have a TD125 and there are only three screws holding the arm board. I installed a Mayware Formula 4 arm and had to make a new arm board of plywood. You really need a table saw and drill press to make sure the new board is perfectly rectangular and the screw holes are perfectly vertical.

 

[AuroraB]

Workshop and tools are no problem

 

[kevinkr]

The details you need should all be available on vinyl engine..

 

[wanders]

Also, check theanalogdepartment.com website. Lots of detail on Thorens tables. As to the question, I believe that only one thrust plate was used for all versions of the td-125. That had three screw holes. Wider arm boards attached the same way as the standard size.

 

[pioux]

Yes i comfirm