diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Analogue Source (http://www.diyaudio.com/forums/analogue-source/)
-   -   michell gyro bearing (http://www.diyaudio.com/forums/analogue-source/229556-michell-gyro-bearing.html)

Bibio 7th February 2013 07:38 PM

michell gyro bearing
 
hello. does anyone know the hight of the bearing from the bottom of the plinth to the top of the bearing where the underside of platter surface rests on the gyrodec?

or if anyone has a complete bearing assembly at hand could they measure the hight from the bottom of the threads to the top surface where the platter rests not including the record/clamp spindle.

thanks

studiostevus 10th February 2013 01:51 PM

Just putting back together my gyrodec after international house move.

Bottom of bearing to platter rest: 53mm
Platter rest to lowest screw winding: 7mm

Bibio 10th February 2013 11:30 PM

thanks you studiostevus.

would the bottom of the bearing be to the top of the plinth or from the very bottom including the base screw (underside of plinth)?

Thanks

studiostevus 10th February 2013 11:48 PM

It's from the bottom (the lowest point) of the bearing, so below the plinth surface

Bibio 11th February 2013 12:15 AM

thank you very much studiostevus. the size is actually shorter than i thought which is great news.

Thanks again. wishing you a happy time in your new house.


All times are GMT. The time now is 01:23 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2