Sony TTS-3000 Project

Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Jump to Latest
inrank

inrank

Member
Joined 2005
Just starting a new project based around the main bits from a Sony TTS-3000.

So far, I have a Pioneer Arm:

An externally hosted image should be here but it was not working when we last tested it.

Pioneer Arm by RSdesignUK, on Flickr

Its from a Pioneer C-4500 music centre (also a PL-12D and PL51A I believe) It has an effective length of 221mm and accepts aftermarket headshells.

And the Motor, Platter/Bearing and PSU from a Sony TTS-3000

An externally hosted image should be here but it was not working when we last tested it.

Sony TTS-3000 by RSdesignUK, on Flickr

Idea is to keep it cheap and simple

Idea V1.1:


TT V1.1 by RSdesignUK, on Flickr


TT V1.1 by RSdesignUK, on Flickr


TT V1.1 by RSdesignUK, on Flickr

Basically a 2mm aluminium top plate to mount the bearing, motor and tonearm. I can get these made at work which helps.
There will be a bottom plate too with a plywood cylinder in between for the motor/bearing and tonearm.
I have also put in a decorative plinth to go around it, pure looks.

There will be some Sorbathane Feet under the TT part and just some spikes for the plinth.

With the platter:

TT V1.1 by RSdesignUK, on Flickr
 
Status
This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
Top Bottom