diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Analogue Source (http://www.diyaudio.com/forums/analogue-source/)
-   -   Phono Pre Amp (http://www.diyaudio.com/forums/analogue-source/221101-phono-pre-amp.html)

cberman 7th October 2012 05:58 PM

Phono Pre Amp
 
6 Attachment(s)
Hi All,

I've been reading these forums for the past few days. I've come up with a schematic and PCB based on the preamp design based on the TI application note "Application Note 1651 Keeping Up with the Expanding Demands of
High-Performance Audio". http://www.ti.com/lit/an/snaa046/snaa046.pdf

I also quickly put together a board for a simple LM317/337 +/-15V power supply.

Attached are the files.

kevinkr 7th October 2012 06:03 PM

:cop: Moved to Analog Source. (Most phono stages are located here.)

Welcome to the forum, posting your project here is a good start! :D

rsavas 11th October 2012 04:04 PM

Looks pretty good,let us know your test results and listening impressions.
May want to place some capacitors across the rectifier diodes to suppress the diodes switching transients.
Only one 100n cap at the LM317/337 inputs is required.
Do not rely on solder mask as an insulator for your heatsinks. Not sure if the will be sitting on the tip layer of the PCB.
Use 1% resistors for the RIAA equilization network & 2% film caps
I do not see any 100n/X7R bypass caps close to the supply pins of the opamps? These are necessary!!

Regards
Rick


All times are GMT. The time now is 01:21 AM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2