|
|||||||
| Home | Forums | Rules | Articles | Store | Gallery | Blogs | Register | Donations | FAQ | Calendar | Search | Today's Posts | Mark Forums Read | Search |
| Analogue Source Turntables, Tonearms, Cartridges, Phono Stages, Tuners, Tape Recorders, etc. |
  |
|
|
|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving |
 |
|
|
Thread Tools | Search this Thread |
15th May 2012, 12:47 PM
|
#1 |
|
diyAudio Member
Join Date: May 2012
|
rega planar 2 motor
Hi, not quite sure how this works, but could do with some advice please. I have dug out my old RG2 turntable. I replaced the lost ball bearing, and it played ok, for 5 minutes, then ran slow. I checked out some reasons, and found if I held the motor spindle, it would slip. So thinking I could take it off and araldite it, I then found It would not pull off the motor spindle. Can anyone advise me please? thanks simon
|
|
|
| Thread Tools | Search this Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rega Planar Motor Vibrating When OFF! | speedboy | Analogue Source | 3 | 28th February 2012 07:53 AM |
| Rega Planar 3 Motor | DIFFO | Analogue Source | 3 | 21st September 2011 01:51 PM |
| Rega Planar 3 | whitelabrat | Swap Meet | 1 | 1st September 2010 04:08 PM |
| Rega Planar 3 Motor(original model) height adjustment? | GCD750 | Analogue Source | 40 | 26th November 2008 01:46 PM |
| WTB: Rega Planar 3 motor upgrade | zacster | Swap Meet | 0 | 1st November 2007 01:14 AM |
| New To Site? | Need Help? |
