Hi.
I've just finished laying out my PCB for a Linn Intek based phonostage and I would like some feedback regarding it layout.
phonostage intek.jpg
I've just finished laying out my PCB for a Linn Intek based phonostage and I would like some feedback regarding it layout.
phonostage intek.jpg
Last edited:
Hi,
Since you have laid out symetrically why not put SW1 down in the
center? (shortens the input trace and make the rest even)It might also be good if you can do a ground pour instead of the many parallel ground return or star ground.(red). singa
PS the mounting holes look too close to the edge of pcb,might be good if you allow more
clearance between trace and hole that means making the pcb slightly larger and for mechanical
soundness or strength as pcb may crack when screws are tightened.
Since you have laid out symetrically why not put SW1 down in the
center? (shortens the input trace and make the rest even)It might also be good if you can do a ground pour instead of the many parallel ground return or star ground.(red). singa
PS the mounting holes look too close to the edge of pcb,might be good if you allow more
clearance between trace and hole that means making the pcb slightly larger and for mechanical
soundness or strength as pcb may crack when screws are tightened.
Last edited:
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.