Has anyone tried to repair a Linn Ittok (bearings)?

[Zoodle]

Would be interested to hear from anyone who has attempted this, even if the outcome was bad.
Thanks in advance.

[kevinkr]

I would ask this question over at the Vinyl Engine | The Home of the Turntable - much more likely to run into somebody who has done this successfully or can tell you why you should send it back to Linn to be serviced.

[Nanook]

look here: audiomods Rega arm conversion kits and DIY mods

I know you stated you have a Linn Ittok, but the basics are similar. Audiomods even has a "how to guide. Only differences may be the bearing cup sizes.

Hope it helps

[Zoodle]

Thanks Kevin,
Unfortunately, Linn no longer support the Ittok... Besides, I like to diy...

Thanks Nanook,
I didn't know that site; looks good. Thanks.

[AVWERK]

While your at it, put some heatshrink over the tube so you won't think it's your phone ringing!

Regards

[Nanook]

"tick tock, Ittok"

[harwoodspark]

You need to get onto this fellow. He'll tell if it can be sorted.

Audio Origami - Everything from custom-made Tone Arms, Arm Rewires, Turntable set-ups, Custom Speaker parts and High Quality Cables, Terminals and Special extra slippery Bearing Oils and Pure Damper Oils.