|
|||||||
| Home | Forums | Rules | Articles | Store | Gallery | Blogs | Register | Donations | FAQ | Calendar | Search | Today's Posts | Mark Forums Read | Search |
| Analogue Source Turntables, Tonearms, Cartridges, Phono Stages, Tuners, Tape Recorders, etc. |
  |
|
|
|
Please consider donating to help us continue to serve you.
Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving |
 |
|
|
Thread Tools | Search this Thread |
23rd February 2009, 06:47 PM
|
#1 |
|
diyAudio Member
Join Date: Nov 2007
Location: NW NJ USA
|
hi output MC=too little gain.
Using Adcom hi output crosscoil MC VDHII cart OR Bang&Olufsen MMC-1 thru Yamaha C2-x preamp/Krell FPB 300/B&W 801Ns, not enough gain thru MM input.
Can turn volume up fully and, although it's pretty loud, it's nowhere as loud as it could/should be. I've installed 10db attenuaters to Tuner & CD to keep all input levels nearer to each other. Adcom is 2.3mv@5cm/s, MMC-1 is 2.12mv@5cm/s, however MMC is slightly louder despite lower rated output. If I run the Adcom hi output MC thru the MC input in the pre and engage the -10db phono swx, it sounds pretty good w/1K ohm loading selected, but is now too loud + my second TT is hopelessly weak in MM input (-10db swx in rear of pre affects all phono inputs). I need more gain, but i don't want a complicated solution to running 2 low ouput turntables. Phil |
|
|
| Thread Tools | Search this Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How to calculate gain and output impedance? | RogerGustavsson | Solid State | 1 | 7th June 2008 05:09 PM |
| Gain Matching Output device ???'s | Zero Cool | Everything Else | 6 | 10th December 2006 04:56 PM |
| Output stage with gain | rtarbell | Solid State | 18 | 27th October 2006 07:15 PM |
| About output pot. value and gain on BoZoS.. | Buhl | Pass Labs | 3 | 12th June 2006 10:01 PM |
| New To Site? | Need Help? |
