analog_sa said:Nice. How did you make the curved finger lift? No bias compensation? Was Cantus the inspiration?
The Cantus was in the back of my mind.
I still need to find solutions for a lifter system and bias system.
Curved finger lift were made by heating the tip with a heat gun and shaping it by hand - hot yes!!
DV
analog_sa said:Forgot the most important (jealous) question: how do you get such clean cuts in the acrylic?
The acrylic I use is protected by vinyl stick-on and I dont remove it until I am done. I cut the plastic with a "jig-saw" that is slowed down with a Variac so that it doesnt melt or rip it. After cutting I straigten the edges by sanding it on a piece of sandpaper placed on a flat surface. Easy.
revintage said:Great build! Just add a jewel V-cup and this is pro-stuff!
Thank you for your kind words Revintage! A friend of mine uses an engineering company that can work with jewel bearings - maybe I must get in touch with him.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.
- Home
- Source & Line
- Analogue Source
- DIY Unipivot - ClearTone