diyAudio

diyAudio (http://www.diyaudio.com/forums/)
-   Analog Line Level (http://www.diyaudio.com/forums/analog-line-level/)
-   -   Yamaha Equalizer 1027 service manual wanted (http://www.diyaudio.com/forums/analog-line-level/226613-yamaha-equalizer-1027-service-manual-wanted.html)

klomp1 29th December 2012 09:50 AM

Yamaha Equalizer 1027 service manual wanted
 
Can anybody supply a service manual or schematic for this equalizer. I have searched the internet and found nothing. I need it for capacitor values and specs as these are work out.

Original Burnedfingers 29th December 2012 10:14 AM

http://www.loadoffun.net/loadoffun/L...amaha%20EQ.pdf

Here is a owners manual.

The cap values are marked on the caps. Check the power supply for correct voltages first. The Eq is only worth about $50 on ebay at best so its not worth a lot of trouble.

You might try Yamaha or see if there is a pro sound contractor in your area as this was a common low priced unit about 33 or so years ago and they should have a schematic. If not its still an easy fix without a schematic. Its an analog unit and not particularly good sounding either.

klomp1 7th January 2013 07:32 PM

Equalizers generates noise in loudspeakers when switched on. When they are switched off from the signal path noise disappears. i have tried both xlr and rca/jack with same result.
Occasionally one channel gives a thump. They are running at max output level on the front side knob.
Any ideas on what could generates this irritating noise?


All times are GMT. The time now is 08:18 PM.


vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2014 DragonByte Technologies Ltd.
Copyright 1999-2014 diyAudio


Content Relevant URLs by vBSEO 3.3.2