diyAudio (
-   Analog Line Level (
-   -   Subwoofer Controller Kit - Altronics Kit No K5562 (

aspringv 11th September 2012 10:28 AM

Subwoofer Controller Kit - Altronics Kit No K5562
Hi All,
Just thought I'd ask if anyone has built this kit? I recently purchased it as I was thinking about the amp setup for a sub I've mostly built and started looking at linkwitz transform circuits and bridging amps... Which led me to the following.

Altronics Kit K5562 - This kit purports to provide automated on/off for your amp setup (VOX Circuit) as well as an adjustable low pass filter ( 4 pole active) and an option to filter freq's below 15hz, compressor limiting, and on/off thump circuitry. Altronics - K5562 Subwoofer Controller Short Form Kit

My questions are - has anyone built this? If so, any tips and suggestions? Part's mods? Circuit changes? The kit dates back to '95 so I figure there's bound to have been improvements since then!

Secondly, I'd like to build in a linkwitz transform circuit to the board too, but I'll need to work out where's best in the circuit to do so... I'm awaiting altronics to allow the circuit to be published here before I transcribe the circuit, and I have a reasonable guess about how to proceed, but I will hit my knowledge boundaries shortly here... :)


aspringv 12th September 2012 02:26 AM

Altronics have approved me publishing the circuit. I'll put a copy up later today.

aspringv 21st September 2012 01:59 PM

bollocks. no scanner and photo a bit rough. i'll do it up in eagle...

andrewlebon 21st September 2012 02:24 PM

sub filter
2 Attachment(s)
even audio sub filter

All times are GMT. The time now is 12:33 PM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 18.75%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Copyright ©1999-2018 diyAudio