Go Back   Home > Forums > >
Home Forums Rules Articles diyAudio Store Blogs Gallery Wiki Register Donations FAQ Calendar Search Today's Posts Mark Forums Read

Analog Line Level Preamplifiers , Passive Pre-amps, Crossovers, etc.

Help me replacing a (they dont have that) op ic
Help me replacing a (they dont have that) op ic
Please consider donating to help us continue to serve you.

Ads on/off / Custom Title / More PMs / More album space / Advanced printing & mass image saving
Thread Tools Search this Thread
Old 2nd June 2011, 06:31 PM   #1
harp mg is offline harp mg
diyAudio Member
Join Date: Mar 2011
Location: here in imerica
Unhappy Help me replacing a (they dont have that) op ic

i wanna know if ne5534 could be replaced wth any other single opamp such tl071 or tl061. the thing that gives me doubts is the pin 5 and 8 of ne5534. if i use a dual opamp or a quad opamp instead what happens. is there a problem or what???

you may get more info of what im saying from this link (figure 4 and 6 and 7):
Audio Mixing Console - Part 1
  Reply With Quote
Old 2nd June 2011, 06:34 PM   #2
tomchr is offline tomchr  Canada
diyAudio Member
tomchr's Avatar
Join Date: Feb 2009
Location: Calgary
The NE5534 is an externally compensated single op-amp. You can replace it with any single op-amp such as LME49710 if you leave pins 1, 5, and 8 disconnected. Either cut the pins off the op-amp, cut the board traces leading to those pins, or pull the components connected to those traces.

  Reply With Quote
Old 2nd June 2011, 07:43 PM   #3
macboy is offline macboy  Canada
diyAudio Member
Join Date: Oct 2003
Location: Ottawa, Canada
Despite the nay-sayers, 5534 is quite good, better than 5532, which is itself quite good. Certainly far better than the ancient TL071. Also the 5534 is bipolar input and TL071 is JFET. If I was designing the circuit originally, it would be different for each opamp based on this. It follows then that simply dropping one in place of the other isn't necessarily a good idea. This is especially true in this circuit where the input impedance has been carefully matched to the characteristics of the NE5534 (input current noise, input voltage noise, input impedance, etc.) in order to minimize noise. Switch to a FET input and all bets are off.

edit: Digi-key has a TI-made NE5534A in DIP

Last edited by macboy; 2nd June 2011 at 07:51 PM.
  Reply With Quote
Old 2nd June 2011, 07:56 PM   #4
Mooly is offline Mooly  United Kingdom
diyAudio Moderator
Mooly's Avatar
Join Date: Sep 2007
Help me replacing a (they dont have that) op ic
Good advice in the above two posts...

my thoughts for what they are worth,
fig 3 which you didn't mention... stick to the NE5534 unless you want to tweak the circuit to work with some newer bipolar device but not an FET device if you want the best noise performance.

fig 4,6 and 7. You could use something like the OPA134 or OPA604 and just omit the compensation cap used for the 5534's but noise will be worse.

Again my thoughts... noise (white noise) is to me one of the least of concerns because the noise levels are so small anyway at line level.

The big problem with the TLO71 is the limited output drive compared to newer devices.
  Reply With Quote


Help me replacing a (they dont have that) op icHide this!Advertise here!
Thread Tools Search this Thread
Search this Thread:

Advanced Search

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Replacing Samson S 3-way Xover Op amps Penguin87 Analog Line Level 7 14th April 2011 06:21 PM
Replacing Bias IC with Individual Transistors scsidude2 Solid State 5 23rd May 2010 07:28 PM
Help replacing TL072CN op amps for TLE2072CP SoundSpot Solid State 4 23rd December 2008 12:31 PM
replacing op-amps in mixer DoomPixie Parts 8 20th October 2005 05:43 PM
Replacing LM318 op-amp Lenin Parts 2 22nd April 2004 12:18 PM

New To Site? Need Help?

All times are GMT. The time now is 07:34 PM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 15.79%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Copyright ©1999-2018 diyAudio