diyAudio (
-   Analog Line Level (
-   -   10band equalizer (

generator***** 17th January 2011 09:30 AM

10band equalizer
3 Attachment(s)
Hi friends. I draw a pcb for 10 band equalizer schematic.what do you think about this pcb?? grounding is ok??

mickeymoose 17th January 2011 05:50 PM

Looks nice! Your layout seems OK. I would mover the part designators (ie R1, R2....) from underneath the parts to the side of the part. This way they are ledgible after assembly. Why the jaggy red (top layer?) lines in the middle? Also I would route all the pot connections to one side for easier assembly. Rotate CON2 so wires exit to fewer sides
This is a cut-only EQ generally used in room eqalization. Personally, I prefer each third filter to go to a different op-amp for a different combining effect.
Well, you didn't ask for all that, but sumtimes I ramble...

generator***** 18th January 2011 11:19 AM

top layer is used for input signal of filters. thanks for advices for part routings

All times are GMT. The time now is 06:07 AM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 18.75%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2018 DragonByte Technologies Ltd.
Copyright ©1999-2018 diyAudio