diyAudio (
-   Analog Line Level (
-   -   Mono to Dual Channel convert (

graygem 3rd January 2011 08:51 PM

Mono to Dual Channel convert
I have the circuit below but would like to just use single gang pot and split the mono after it. Any help is appreciated.

bob91343 3rd January 2011 11:06 PM

What is that supposed to do? If the pot is as drawn, you will get virtually no output regardless of setting, since the signal gets grounded before it goes to the output.

I am wondering what possible use this could be.

Bill Fuss 4th January 2011 12:04 PM

A very small hand warmer?

A single pot with the wiper feeding 2 10K Rs each feeding the amp inputs is what you are after. Where did you get that circuit?

Actually, all you have to do is parallel the inputs.

graygem 4th January 2011 03:28 PM

My mistake in drawing. The wipers are not the grounded pins.
Here's the corrected one. Thanks.

Speedskater 4th January 2011 08:26 PM

1 Attachment(s)
Why not something like this?

graygem 5th January 2011 04:42 PM

1 Attachment(s)
Would this do the job? The output is going directly into a NJM2073 amp. The input is coming from some kind of preamp. I cut down the r9 resistor to 470 because of the paralleled r9/r10. I don't know if I would have to do anything to the caps and res after the pot. Again, any and all help is appreciated.

Bill Fuss 5th January 2011 05:18 PM

The wiper should be your output, not input. And the 4.7k voltage dividers aren't necessary.

graygem 7th January 2011 02:57 PM

Ok, here is my full schematic along with the proposed changes that were suggested. Thank you all.

All times are GMT. The time now is 07:42 AM.

Search Engine Optimisation provided by DragonByte SEO (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Resources saved on this page: MySQL 18.75%
vBulletin Optimisation provided by vB Optimise (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Copyright ©1999-2017 diyAudio