diyAudio - Mic, Line, EQ... Preamps

Page 1 of 39

Last »

Show 50 post(s) from this thread on one page

diyAudio (http://www.diyaudio.com/forums/)

- Analog Line Level (http://www.diyaudio.com/forums/analog-line-level/)

- - Mic, Line, EQ... Preamps (http://www.diyaudio.com/forums/analog-line-level/167363-mic-line-eq-preamps.html)

apexaudio

23rd May 2010 06:44 PM

Mic, Line, EQ... Preamps

1 Attachment(s)

In this thread I will post preamps, EQ, active x-overs, VU...
ML3 is Mic/Line XLR preamp with three band EQ +/-20dB
PCB size 100x40mm
Regards

adason

23rd May 2010 09:20 PM

Quote:

Originally Posted by apexaudio (Post 2196326)

In this thread I will post preamps, EQ, active x-overs, VU...
ML3 is Mic/Line XLR preamp with three band EQ +/-20dB
PCB size 100x40mm
Regards

brink it on, looking forward to it...
btw it would be better posting it in sources & line level signal section
than amplifiers

Gordy

24th May 2010 12:15 AM

Mile, I like to ask... what software is used to produce the diagram in post #1 ?

Thank you.

apexaudio

24th May 2010 05:56 AM

Quote:

Originally Posted by Gordy (Post 2196558)

Mile, I like to ask... what software is used to produce the diagram in post #1 ?

Thank you.

'CorelDRAW12'
Regards

apexaudio

24th May 2010 06:03 AM

Quote:

Originally Posted by adason (Post 2196434)

brink it on, looking forward to it...
btw it would be better posting it in sources & line level signal section
than amplifiers

In thread about PA amps I have request for balanced input, mic preamp, tone controls, activ sub x-over, VU... and I started new thread about this circuits.

Gordy

24th May 2010 07:52 AM

Thanks Mile. I am looking forward to hearing more from you!

apexaudio

24th May 2010 08:25 AM

1 Attachment(s)

I find an old ML3 pcb, schematic must be draw again.

electra_ina

24th May 2010 09:33 AM

Ahaa... I will follow this thread...may be I will built it...
Hvala ti..

apexaudio

24th May 2010 11:47 AM

ML3 is general purpose preamp, can be used for mic, guitar, keyboard... or channel preamp for diy mixer.

smartx21

24th May 2010 12:58 PM

Good job, Mile!
This will be quite useful for many people I know. That includes me!

All times are GMT. The time now is 02:01 PM.

Page 1 of 39

Last »

Show 50 post(s) from this thread on one page