Need help designing custom pbc board

[marchewd]

Hello,
This is going to be my first experience with a scratch built project. I am going to build a Transcendent Sound Grounded Grid tube pre-amp and I need some help laying out the components and finding some where to make the pcb boards. I am just nervous, as I do not want to screw up the component layout since I am a novice, in terms of reading and understanding schematics. I have the schematic, as well as the cap/resistor sizes. Any and all help would be greatly appreciated!
Thanks,
Dan

[leadbelly]

1) You are in the wrong forum, you should have posted this in Tubes

2) This has been discussed; you should at least search a bit. Here is a good thread whwere the PCB design has been posted Grounded Grid Preamp Project And Possible Group PCB Buy

[marchewd]

I have built three GG kits. I am just looking for someone to help me layout the components I have a find someone to manufacture the pbc boards. I already have all of my parts (Mundorf SIO coupling caps, BG power caps, Mills resistors and such). These items would not fit neatly on the stock pbc boards, so I need to design some pcb boards that will fit the components and add the muting circuit on the pbc boards.

Dan