Hello,
I have a question about using a Tip switch on an audio jack. I want to determine when the user connects a headphone jack (or 3.5mm TRS connector) into the device. I am using a SJ-43515TS-SMT Audio Jack and a high(3.3V), low(0V) output needs to be sent to a microcontroller.
I cant figure out a way so that the ac sound wave doesn't couple back to the digital input.
This is the pinout:
Pin 1: Sleeve
Pin 2: Tip
Pin 3: Ring
Pin 4: Ring
Pin 5: Switch (connected to pin 2 when no plug inserted/open when plug is inserted)
Whats the most efficient way of completing this task?
I have a question about using a Tip switch on an audio jack. I want to determine when the user connects a headphone jack (or 3.5mm TRS connector) into the device. I am using a SJ-43515TS-SMT Audio Jack and a high(3.3V), low(0V) output needs to be sent to a microcontroller.
I cant figure out a way so that the ac sound wave doesn't couple back to the digital input.
An externally hosted image should be here but it was not working when we last tested it.
This is the pinout:
Pin 1: Sleeve
Pin 2: Tip
Pin 3: Ring
Pin 4: Ring
Pin 5: Switch (connected to pin 2 when no plug inserted/open when plug is inserted)
Whats the most efficient way of completing this task?
/sreten.
- Status
- This old topic is closed. If you want to reopen this topic, contact a moderator using the "Report Post" button.