Go Back   Home > Forums > Blogs

My efforts in using SE-SE rework boards will be blogged because it has become a distraction from the build thread and is likely to remain the 'path less followed'. Had Owen not encouraged the first of the variants I might have given up on it.

Deeper into variant one

Posted 12th January 2012 at 11:47 AM by Wolfsin (SE-BRGD a bridged mono 'wire')
Updated 12th January 2012 at 11:54 AM by Wolfsin

Will be fleshed out with image of reversed wiring for inverted channel
diyAudio Member
Posted in Uncategorized
Views 540 Comments 0 Wolfsin is offline


Posted 11th January 2012 at 11:16 PM by Wolfsin (SE-BRGD a bridged mono 'wire')
Updated 12th January 2012 at 11:13 PM by Wolfsin (rename second variant)

When asked where frankenwires were to be filed, qusp replied

Originally Posted by qusp View Post
file it under mutants...

...and their amplifiers
There are two variants of what I originally called the SE-BRGD frankenwire. Both start as rework boards. One gets a pair of LME49860 to replace the LME49990 using the simple surgery below. The + and - inputs to the second 49860 are reversed and resistors adjusted so the gain is equal on both sides. The effect of that reversal is to invert the signal on the second leg so it becomes a mono amp, whose differential outputs are ready to bridge one can.

The second variant, more correctly referred to as the BAL-BALM, requires no rework surgery (so could just as well not even be a rework pcb), just the addition of a tiny adapter to mount an opa1632 and leave off the 49990s. Power connection is not as clean as the first variant. It is effectively half a BAL-BAL, perfect for the audiophile with only one ear.

Attached Thumbnails
Click image for larger version

Name:	half-reworked.JPG
Views:	465
Size:	43.9 KB
ID:	564  
diyAudio Member
Posted in Uncategorized
Views 879 Comments 0 Wolfsin is offline

New To Site? Need Help?
Copyright 1999-2017 diyAudio